[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Errors after saving rulebase
Check the searchable archive for this mailinglist but if I remember correctly - on NT this can be caused if you have too many old policies in the ~\FW\conf directory. You can delete old policies via the GUI but the corresponding .W and .pf files have to be removed manually from the directory. I tend to err on the side of caution by keeping the last few policies as well as the current one. Also we move the old .W and .pf files to a subdirectory rather than deleting immediately. Regards, Jenny -----Original Message----- From: Nils Kolstein [mailto:[email protected]] Sent: 09 May 2001 09:35 To: FW-1 Mailinglist (E-mail) Subject: [FW1] Errors after saving rulebase Hi, Since a few weeks I encounter the following problem when trying to save the rulebase.. After a while the GUI shows a pop-up with "No reply from server". It then continues to save the rulebase, which is succesful.. When I close the GUI, it says "Incorrect reply from server (seq or subject mismatch)" What is the problem?? The rulebase is correctly saved and new rules are applied.. Hope someone has a clue.. Nils Kolstein Internetworking Engineer ICT Access Services Planet Media Group E-mail: [email protected] tel: (+31)============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|