|
|
|
|
|
|
|
|
 |
 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] How to GET GUI Access from a remote module
Or to answer the question correctly :), make sure that the $FWDIR/conf/gui-clients has the IP address of your GUI station. >>> "Robert MacDonald" <[email protected]> 11/27/00 9:07:56 AM >>> > >Benjamin, > >Are you running the Windows GUI or Motif? > >The GUI needs to communicate with the fw manager. >The fw manager then communicates with the fw >modules. If the GUI must pass through a fw to >communicate with the fw manager, then you must >allow this in the rulebase. The fw modules must allow >the fw manager to communicate with them. > >On the fw module, the file $FWDIR/conf/masters must >contain the IP/alias of the fw manager. On the fw mgr, >the file $FWDIR/conf/clients must contain the IP/alias >of the fw module(s). > >You will need to make sure that the keys are the same >on both(all) the fw mgr and modules. > >HTH, >Robert > >- - >Robert P. MacDonald, Network Engineer >Team Lead, e-Business Infrastructure >G o r d o n F o o d S e r v i c e >Voice:email: [email protected] > >>>> "benjamin.c" <[email protected]> 11/27/00 3:54:30 AM >>> >> >>Hi guys, >> >>can some tell me , what do i need to setup on a firewall >>management station to connect to a remote module. >> >>i have a firewall install, with access to another gateway. >>and all the firewalls in my building get controlled by a management station >>called lets say BLINK. and then firewall i need to connect to is called ME. >>so were do i need to setup the GUI access. on the management and on the >>firewall. >> >>System Administrator >>http://www.Apocolips.org.uk ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
