[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Problem after changing Ethernet card
Just some ideas, Are you using NAT? If so you may need to change the static arp entries. If this is more general problem then maybe the arp cache on the next hop router needs to be flushed, some useful info would be if this is an external interface and is NAT being done? Also, is any traffic at all making to the firewall through this interface. Try a ping and see if the arp cache of the router/host picks up the new addess. Hope this is a help. Russell Goodwin -----Original Message----- From: Sridhar Gupta [mailto:[email protected]] Sent: 03 October 2000 09:52 To: [email protected] Subject: [FW1] Problem after changing Ethernet card Hi Everybody, I am facing following problem, My firewall was running fine. I want to change on of the Ethernet card connected to the system. I canged it. Suprisingly Firewall functionality is not working. Then I brought back the old card and inserted it. It started working. After changing the card Installed the correct driver. Is there any where MAC address is written to FW. Please suggest me the solution. Thanks in Advance. gupta. _________________________________________________ Get Your Free Email At, http://www.rediffmail.com For fabulous shopping deals visit: http://www.rediff.co.in/shopping/index.html ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|