|
|
|
|
|
|
|
|
 |
 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] AW: [FW-1] NG on Multiple Processors
At 22:12 24.07.2003 +0200, you wrote: > > CPMP-MPU-1-NG Multi-CPU Support for 1 Enforcement Point > So that sounds a little bit...unbeleavable. As I understood, you don' t have to buy CPMP-MPU-1-NG Multi-CPU Support but without it only one CPU is used by fw-1. Let's discuss the following scenario: Once I bought a E220 with 2x Ultrasparc II. As firewall software CP 4.1 was installed. With 4.1 you could use multi processors without any additional no, 4.1 does not support multi-CPU. use an eval-license and check how much faster your fw is with multi-CPU-support enabeled and then find your decision. cheers reinhard -- Reinhard Stich, ASSIST [email protected] Internet Security AG, 1190 Wien, Nussdorfer Laende 29-33 Tel: +43 1 370 94 40 RS784-RIPE Fax: +43 1 370 94 40-10 ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
