[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW-1] StoneBeat Multicast configuration problem
Hello, I need help with cluster configuration, I setup a two node cluster with Firewall-1 NG FP1 and StoneBeat Fullcluster 3.0 HF 2 over Solaris 8 in 64 bits mode. The cluster has 11 ONICS. It appears that I missing somethig on NG, StoneBeat or Switch configuration. I would appreciate any sugestion. The problem is that I need to configure multicast in thecluster because it is connected to switches and to avoid flooding I configured them, but the conections are unstable. The switches are: Catalyst 6500 WS-C6509 Software, Version NmpSW: 5.3(2)CSX Copyright (c) 1995-1999 by Cisco Systems NMP S/W compiled on Oct 11 1999, 17:45:02 System Bootstrap Version: 5.2(1) Hardware Version: 2.0 Model: WS-C6509 Serial #: SCA03460139 Catalyst 4000 WS-C4003 Software, Version NmpSW: 5.1(1a) Copyright (c) 1995-1999 by Cisco Systems, Inc. NMP S/W compiled on Jun 25 1999, 15:35:49 GSP S/W compiled on Jun 25 1999, 11:55:45 System Bootstrap Version: 4.4(1) Hardware Version: 1.5 Model: WS-C4003 Serial #: JAB03210A95 Mod Port Model Serial # Versions --- ---- ---------- -------------------- --------------------------------- 1 0 WS-X4012 JAB03210A95 Hw : 1.5 Gsp: 5.1(100) Nmp: 5.1(1a) 2 48 WS-X4148 JAB032906VN Hw : 1.6 3 48 WS-X4148 JAB0329071B Hw : 1.6 The cluster is connected to Catalyst 4000, this switch has propagated VLANS from Catalyst 6500 via truncking. The Cat. 6500 has a routing module too. I tested just with 2 ONICS an configure the Cat 4000 with "set cam permanent" command and assign the multicast mac to the ports connected to nodes. In the router module I set a static arp entry so it can "see" the cluster. Every thing was OK until I connected all the rest ONICS with the respective configuration. The ping shows that sometimes there is loop between the cluster and the router that made expire TTL. Thanks in advance, Manuel Cabrera ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|