[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] StoneBeat and 3Com Problem
You need to setup a CAM entry in your switches that binds the two firewall ports together. I.e. you need to turn the switch into a hub, as far as these two ports are concerned. On your router, you also want to bind the MAC multicast to the VIP of the complex. Make sure you do that for each interface. George > -----Original Message----- > From: Darren Stewart [SMTP:[email protected]] > Sent: Friday, May 04, 2001 2:35 AM > To: [email protected] > Subject: [FW1] StoneBeat and 3Com Problem > > I am having a problem with the StoneBeat Load Balancing software. I have > the following setup. > > 2xFirewalls > 1xManagment Server > > Running SunOS 5.7 and FW1 4.1 SP2 > StoneBeat 4.2.1 > > they are connected to 3com 3300 switches running software version 2.64. > > The problem is when both firewalls are on line traffic only flows through > one but slows the network down to a virtual stop. If i connect them to a > hubs and then into the switches it all runs fine. Is there any special > settings that need to be done on the switches as they are listed in the > compatibility guide. > > > > > Thanks. > > > Darren Stewart > Data Technician > > > Stockport Borough Council > [email protected] <mailto:[email protected]> > > > > _____________________________________________________________________ IMPORTANT NOTICES: This message is intended only for the addressee. Please notify the sender by e-mail if you are not the intended recipient. If you are not the intended recipient, you may not copy, disclose, or distribute this message or its contents to any other person and any such actions may be unlawful. Banc of America Securities LLC("BAS") does not accept time sensitive, action-oriented messages or transaction orders, including orders to purchase or sell securities, via e-mail. BAS reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the BAS e-mail system. ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|