Re: [FW1] Sun+CPfw1+Stonebeat HA-Snoop=Interface Problem ????

["Malang" <malang@FW1-NOSPAMnyc.rr.com>]

Check to see if auto negotuation is turned on. 2.6 does not like auto-neg.
In a switched environment,
hard set the interface speed/mode. You can use ndd to find out if you are
auto negotiating.

Malang

----- Original Message -----
From: Rodrigo Borges <Rodrigo.Borges@lis2.siemens.pt>
To: <fw-1-mailinglist@lists.us.checkpoint.com>
Sent: Thursday, March 22, 2001 6:28 AM
Subject: [FW1] Sun+CPfw1+Stonebeat HA-Snoop=Interface Problem ????


>
> Hi,
>
> I'm installing the Stonebeat HA version 3.1 and I have the following
> configuration:
>
> Hardware:
> 2 Sun Servers 220R with 1 Quad cards. I use qfe0 - qfe1 to connect to our
> network segments through the switches and use a cross over UTP cable to
> connect the hme0 network cards together. I also use serial link between
the
> two Firewalls or heartbeat. The external interfaces qfe0 and qfe1 have the
> same IP and MAC address on both nodes.
>
> Software:
> Solaris 2.6
> CheckPoint FW-1 V4.1
> StoneBeat V3.1
>
> Problem:
> When I mannualy switch from PRIMARY to SECONDARY, connectivity is lost.
But
> if I do a SNOOP on the interfaces before the switch everything is OK.
> The same applies if I want to get back to PRIMARY from SECONDARY.
>
> Is this a Stonebeat or an interface problem?
>
> Have anybody saw something like this? Does it make any sense?
>
> Rodrigo
>
> _____________________________________________________
>
> Rodrigo Borges
>
> TAC Support, IC ICS IP&A
> SIEMENS SA, Information & Communications
> Phone: +351 21 4242220
>
>
>
>
============================================================================
====
>      To unsubscribe from this mailing list, please see the instructions at
>                http://www.checkpoint.com/services/mailing.html
>
============================================================================
====



================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================