[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] No Install Targets for rule #
Hi, In either case - Single Gateway product or distributed you have to create an object where the policy needs to be installed. As I understand you have not created the object, create an object and select the same in the policy editor. regs sathish m r On Tue, 10 October 2000, Rodrick Brown wrote: > > > > I keep getting these erros when trying to install my Security Policy rule. > > Im going to Policy tab hit Install it gives the following > "No machihnes eligible for Policy Installation!" > > Or if i go to the Policy tab hit verify it says > "Security and Address Translation Policy Verification: " > No install Targets for rule 1, 2, 3, etc... > I dont know what I could have done wrong. =\ > Anyone have a walk through paper online I could use it would be really > greateful. > > Please cc a copy to [email protected] > > > - Rodrick Brown > > > > ================================================================================ > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================================================ ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|