[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] VLAN-Checkpoint
Typically in this scenario, all of your clients would use your layer 3 switch as their default gateway (the layer 3 switch is mutli-homed, so each client points to the interface of the switch for their respective VLAN), and the switch itself uses the firewall as its default gateway. Then, create routes on the firewall to direct traffic for all the VLANS back to the layer 3 switch. Please write me back directly if I'm not making sense. Dan Hitchcock CCNA, MCSE Network Engineer Xylo, Inc. (formerly employeesavings.com)The work/life solution for corporate thought leaders -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: Thursday, October 05, 2000 9:02 PM To: [email protected] Subject: [FW1] VLAN-Checkpoint Hi all, Present setup : CP Firewall 4.1 Layer2 Switches used in the Private zone Layer2 Switches used in the DMZ zone (total three zone : 1. External (connected to the internet) 2.DMZ 3.Private. Natting is done on the firewall to Class B IP Address range. Later we are planning to shift to Layer3 switching internally. i.e VLAN's. In Case of VLAN's what will be my gateway, is it the firewall for all the subnets, if yes does that mean all the traffic flows thru single firewall interface ? or is that I have to create multiple virtual interfaces on the firewall ? pl suggest how to go about it... thanks regs sathish m r ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|