| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] Con not connect through VPN
- To: [email protected]
- Subject: Re: [FW-1] Con not connect through VPN
- From: Chris Hoff <[email protected]>
- Date: Thu, 30 Oct 2003 11:49:20 -0500
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcOfBODRbTvDREL7RQOQffjnnM306wAAFYLA
- Thread-topic: [FW-1] Con not connect through VPN
Trevor,
If you are using 4.1 (as your previous post indicates), you will not get
an allocated IP address on the client. The only way this shows up is if
you are using Office Mode in NG.
I would check to be sure your Encryption Domain is setup correctly so
when the SecuRemote Client downloads the topology it knows what IP
addresses are behind the firewall. If you find you have to change the
Encryption Domain, make sure you update the topology on the SecuRemote
Client before attempting to connect.
Good luck,
Chris
-----Original Message-----
From: Trevor Dixon [mailto:[email protected]]
Sent: Thursday, October 30, 2003 10:59 AM
To: [email protected]
Subject: [FW-1] Con not connect through VPN
Yes I think it may have something to do with allocating IP address
because when I run "ipconfig /all" on the client; there is no sign of an
allocated IP address. Anybody know how to address this??????
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
