[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] NG AI VRRP Cluster not clustering
hi,
first of all: did you configure the "monitored interfaces" to dicrease the
priority on the master for the other interface?
another thing: if you do a "cpstop" on both nodes and disconnect one
interface - does vrrp work?
cheers
reinhard
At 19:01 07.10.2003, you wrote:
Hi,
I have a just put my second IP 330 (IPSO 3.7 B27) together with my so far
running fine IP330 into a VRRP cluster.
Both same hardware and os, both NG AI.
I set up VRRP and all the stuff, all fine. Smart status says Cluster is
okay.
VRRP monitor on voyager also says the master is master and the backup is
backup. When I shut down one interface of the master for testing, the slave
only takes this one interface into the master state, so the cluster finally
does not work.
I checked helos and prio deltas, master has a prio of 100, slave 95, delta
is on both 10 for all VRIDs. With exactly the same setup the VRRP cluster
worked few weeks ago with 4.1 SP6 on IPSO 3.5. I looked through Nokia
Support 1512 and re-checked, but it is everything like I would expect it. So
where's the heck with IPSO 3.7 and AI? What changed?
Thx for any hints.
Steffen
PS: The VRRP and sync rules are also okay...
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
--
!! NEUE SNAIL-MAIL-ADRESSE !!
Reinhard Stich, ASSIST [email protected]
Internet Security AG, 1150 Wien, Johnstrasse 29
Tel: +43 1 3709440 RS784-RIPE Fax: +43 1 3709440-10
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
