[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW-1] Creating a Cluster Object in Checkpoint NG+AI
I am having a problem adding gateways to the cluster object that I created. I am running Nokia in VRRP mode and IPSO 3.7. When I add two gateways to the cluster and in 3rd Party Configuration Nokia VRRP is selected as a 3rd Party Solution I get the following warning message. Interface "eth1c0" of cluster member "member name" is marked as shared cluster, however its IP doesn't belong to any of the Member networks of the cluster's interface. -To mark it as private interface of the cluster, uncheck "Cluster Interface." -To mark it as a shared interface, change its ip address to be in the corresponding cluster Interface member network. Leave it as is will cause it to be treated as a private interface of a member. When I select in 3rd Party Configuration OSPEC I do not get this warning message. Did anybody else see this before and does anybody know what causing this warning message to pop up. Thanks Max *************************************************************************** This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail or its attachments. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Amalgamated Bank therefore does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. If verification is required please request a hard-copy version. ****************************************************************************** ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|