[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW-1] Upgrade = SC down
Hello, Has anyone seen the following issue, and found the way to solve it ?? Configuration : - Till this morning : W2k Mgmt Server with NG FP3 + HF2 and HFA_309 HA Cluster of IP440 with IPSO 3.6-FCS6 and NG FP3 + HF1 and HFA_305 The whole configuration has been upgraded in different phases from 4.1-SP2 to NG FP3, the IP440 were also upgraded from 3.2.1 to 3.3 to 3.5 to 3.6 - After the 'upgrade' : W2k Mgmt Server with NG FP3 + HF2 and HFA_315 HA Cluster of IP440 with : Master -> IPSO 3.6-FCS7 and NG FP3 + HF2 and HFA_315 Backup -> IPSO 3.6-FCS6 and NG FP3 + HF1 and HFA_305 This time the 'upgraded' system has been installed from scratch - Problem : --> when the upgraded system is Master everything works fine with the exception to the SC clients that can't connect ... they get an error message stating the Policy Server is outdated ... and asks to use UDP encapsulation as far as I can understand --> when the old backup system becomes Master everything works as expected again Nothing has changed in the policy !!! The exact same policy is applied to both members. I looked in the vpnd.elg and dtpsd.elg files but couldn't find anything related to this problem. Any help, insight or advise appreciated. Met vriendelijke groeten - Bien à vous - Kind regards Guy ROELANDTS EMEA GS Internet Expertise Centre - CCSE-NG Hewlett-Packard Belgium B.V.B.A./S.P.R.L. E-mail : [email protected] Tel: +32(02)729.85.61 Fax: +32(02)729.77.65 ========================================================== This message may contain confidential and/or proprietary information, and is intended only for the person/entity to whom it was originally addressed. The content of this message may contain private views and opinions which do not constitute a formal disclosure or commitment unless specifically stated. Should you receive this message by mistake please inform the sender immediately. ========================================================== ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|