[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] HA & Stonebeat
If you are going to use the cluster in a load sharing setup I believe it is required or you would have un-synced packets being dropped on one of the cluster nodes. You can check to see if the ha/sync module is working by issuing the following commands on any of the nodes in the cluster, since you are using a third party clustering solution these do not always show the whole truth, but they will tell you if FW-1 is working. - fw ctl pstat (Check the output at the bottom for sync and ha info) - cphaprobe stat (This shows which nodes are currently active) Chris C. Burton Network Engineer Walt Disney Internet Group: Network Services -----Original Message----- From: Vogel, Jochen [mailto:[email protected]] Sent: Monday, September 08, 2003 9:33 AM To: [email protected] Subject: [FW-1] HA & Stonebeat hi, i use CP NG FP3 and Stonebeat 3.0 on Solaris 9. -must the CP HA / State Sync Option in cpconfig be enabled? -is there a simple way to control if the sync works? thx for help jo ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|