| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] NG AI vpn issues
- To: [email protected]
- Subject: Re: [FW-1] NG AI vpn issues
- From: Lars Troen <[email protected]>
- Date: Wed, 3 Sep 2003 15:55:02 +0200
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcNyIl06fksJZN63RJu6iSalbx0tiQAAE3Vw
- Thread-topic: [FW-1] NG AI vpn issues
- Are you using Securemote NAT?
- An internal router that packets go through?
- Used a sniffer on the internal LAN?
-----Original Message-----
From: Matt Kehler [mailto:[email protected]]
Sent: 3. september 2003 15:25
To: [email protected]
Subject: [FW-1] NG AI vpn issues
We now have our NG AI client to site VPN working (it was a licensing
issue). Well, not really working. All I can see is the internal
interface of the firewal. (2 interfaces). I can ping the inside
interface of the firewall, but nothing else (ie, nothing else inside,
even nodes on the same network as the internal interface). logs show my
attempts as accepted. nothing comes back though. I do not believe its
a routing issue, as i have (had) the exact same VPN setup using Novell
Bordermanger; i just swapped the checkpoint in for now. Could this be a
topology issue? Currently it is set to 'all IP's behind gateway based on
topology'
thanks
Matt
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
