| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] NG FP2 cpconfig -- reset
- To: [email protected]
- Subject: Re: [FW-1] NG FP2 cpconfig -- reset
- From: "Roelandts, Guy" <[email protected]>
- Date: Wed, 3 Sep 2003 13:10:03 +0200
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcNxZyOExWw164gMRA2NuIiQGz18PQApKIfw
- Thread-topic: [FW-1] NG FP2 cpconfig -- reset
Ben,
This has been discussed in the past on this mailing list or on the one
from PhoneBoy ... It was said there you only had to remove the product.conf
file to start over again ...
Met vriendelijke groeten - Bien à vous - Kind regards
Guy ROELANDTS
EMEA GS Internet Expertise Centre - CCSE-NG
Hewlett-Packard Belgium B.V.B.A./S.P.R.L.
E-mail : [email protected]
Tel: +32(02)729.85.61
Fax: +32(02)729.77.65
==========================================================
This message may contain confidential and/or proprietary information,
and is intended only for the person/entity to whom it was originally
addressed. The content of this message may contain private views and
opinions which do not constitute a formal disclosure or commitment
unless specifically stated. Should you receive this message by mistake
please inform the sender immediately.
==========================================================
-----Original Message-----
From: Ben Cuthbert [mailto:[email protected]]
Sent: Tuesday, September 02, 2003 5:07 PM
To: [email protected]
Subject: [FW-1] NG FP2 cpconfig -- reset
All
I remember in 4.1 you were able to reset cpconfig by
removing the products.conf file, how does one go about
doing it in NG.
__________________________________________________
Yahoo! Plus - For a better Internet experience
http://uk.promotions.yahoo.com/yplus/yoffer.html
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
