[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] Manual NATs on FW-1 NG
> I have setup a test firewall on windows2000 pro with FW-1 NG > FP3 I have one > PC on the inside network if I set up the PC on the inside NAT > hiden behind > the firewall IP its ok but if I try to use auto or manual NAT > it wont work I > don't have anyything like tcpdump on the PC to see what is > happening, I > looked through previous postings and on phoneboys website and > tried static > routes as below > > Route -p add outsideaddress inside address > > And this still did not work although I thought NG did all > this and the proxy > arps for you, Do you have 'Automatic ARP configuration' checked in the NAT tab in global properties? Are the packets showing up in the FW logs as accepted? On 2000 you can use netmon to monitor interface packet activity. See if you can see them there. Hal > > Any advise much apreciated. > > Regards > > Kev > > ********************************************************************** > Kevin Barrass > Network Support Officer > South West Yorkshire Mental Health NHS Trust > Information Services > Fieldhead, Ouchthorpe Lane > Wakefield, WF1 3SP > * 01924 327551 > * [email protected] > ********************************************************************* > Providing IT services to: > South West Yorkshire Mental Health NHS Trust > Eastern Wakefield Primary Care NHS Trust > Wakefield West Primary Care NHS Trust > > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [email protected] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [email protected] > ================================================= > ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|