NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FW-1] NG AI VRRP Anti-Spoofing


  • To: [email protected]
  • Subject: Re: [FW-1] NG AI VRRP Anti-Spoofing
  • From: David Beattie <[email protected]>
  • Date: Fri, 25 Jul 2003 16:18:22 +0100
  • Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
  • Sender: Mailing list for discussion of Firewall-1 <[email protected]>
  • Thread-index: AcNSh21uYQS5/HFnRDO/LzONf+2YiQAGMfLQAAVbxyAAAY3Y4A==
  • Thread-topic: [FW-1] telnet problem between cluster members

Rob,

This was a new installation. Cleaned IPSO3.6FCS6 upgrade to IPSO3.7 and then add a fresh install of NG AI. I have checked the NICs, IP addresses (Interface and virtual), subnet masks and routing.

Thanks

Dave

-----Original Message-----

Was this an upgrade or a new install.  There was a post back on 7/17/2003 with a situation with NG-AI and spoofing going beserk.  In that instance it was an upgrade and for some reason when checkpoint upgraded itself, it swapped the nics in the topology table and that was screwing everything up.  I would do a get on the topology table first to make sure that your nics are in the right spot with the right ip addresses before you look further into this.

Rob
** Below is the past of the email about the spoofing issue from 7/17 **

Resolved... My system now has the spoofing working OK, and it's not
complaining about excessive hosts.

I did the interface "find" click. It actually flipped the 2 NIC entries over
(kept the same name, same IP and all) but just reordered them on the FW
gateway's NIC list....
All is well. Evidently, it's picky about how it finds the NIC cards on the
PCI buss, even though the Names & IP's match, it has to something else
particular to Checkpoint's interpretation.

Thanks for the tips & help, guys.
Vic

-snip-

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.