[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW-1] Interface Addressing
Currently I have a FW ( Nokia Ip440, CP 4.1) that on the external Interface there are two IP address ranges. I want to add a third, but I can't get the new IP's to work. On the FW Workstation Properties / Interface Tab it looks like this for the external interface: eth-s1p1c0 .5.101.18 255.255.255.0 The IP's that work are .5.101.18/28 and xxx.5.101.227/28 where xxx = is the same I want xxx.49.154.32/27 to work. Does the entry that is in the Interface Tab cover the first two ranges? And by not having an entry for the new IP cause it not to work? I also noticed that there are more Interfaces installed on the Nokia than show up in the Tab - as in I've two more 4-port cards to the box and none of them are showing up, but all 8 of those Interfaces are working, but none of them are 'real' IP's - they are all for internal use. If I have to add the new IP - do I do it manually or let the FW do it by using the Get function? VJ Picotte Manager, Information Security Department National Commerce Financial Corporation****************************************** ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|