[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] AW: [FW-1] Redhat 7.3 & CPfw1-41.6-SP6.i386.rpmconflicts
Hi there for CP FW1 4.1 < SP3 it's recommended to use Red Hat 6.0-6.3 for Service Packs >= SP3 it's OK to install Red Hat 7.0. it's working fine! Best Rgds Jochen >>> "[email protected]" <[email protected]> 26.02.2003 16:08:04 >>> joerg, andrei is talking about 4.1 release - fw1 4.1 dont support 2.4 kernel only 2.2.x - i suggest using redhat 7.0 and the latest kernel 2.2.22 from ftp://updates.redhat.com/7.0/en/os/i386/ with fw-1 4.1 for me the kernel 2.2.22 is only running with 4.1SP6 ...you can install SP6 with rpm -i -replacefiles CPfw1-41.6-SP6.i386.rpm cheers ad Zitat von Joerg Fritsch <[email protected]>: > Hello, > > this had been discussed on the list for several times. You are not running a > supported kernel-version. > > If you have a valid software subscription with checkpoint you could dl it at > > http://www.checkpoint.com/support/downloads/bin/vpn_des/firewall1/ng/fp3/lin > ux/2.4.18-5/kernel-2.4.18-5.i686.rpm > > If not you might have some luck to find the supported kernel at > http://www.kernel.org. > > --Joerg > http://www.firewalls-illustriert.de > > > > -----Ursprüngliche Nachricht----- > Von: Andrei Grant [mailto:[email protected]] > Gesendet: Dienstag, 25. Februar 2003 18:34 > An: [email protected] > Betreff: [FW-1] Redhat 7.3 & CPfw1-41.6-SP6.i386.rpm conflicts > > > Hi > > When I try to install CPfw1-41.6-SP6.i386.rpm on Redhat 7.3 with 2.4.18-5 > kernel installed > > I get the below; > > Even though compat-libstdc++-6.2-2.9.0.16.i386.rpm is already installed ! > > Can someone put me straight what is going wrong... > > rpm -ivh --force /home/andreigr/CPfw1-41.6-SP6.i386.rpm --nodeps > Preparing... ########################################### > [100%] > Installation started... > > ************************************************************ > > Your OS version is: Red Hat Linux release 7.3 (Valhalla) > To operate properly with this Linux OS version, > Check Point VPN-1/FireWall-1 requires that you install > an additional package (included on the disc) - compat-libstdc++. > Please install it. > > ************************************************************ > > /bin/tar: /opt/CPfw1-41/conf_before_sp6.tar: Cannot open: No such file or > directory > /bin/tar: Error is not recoverable: exiting now > ERRNO:05 > Error saving conf directory. > error: execution of %pre scriptlet from CPfw1-41.6-SP6 failed, exit status 1 > error: install: %pre scriptlet failed (2), skipping CPfw1-41.6-SP6 > > tia > > Andrei > > > > ----------------------------------------------------------------- > This email and any files transmitted with it are confidential and intended > solely for the use of the individual or entity to whom they are addressed > and others may not distribute, copy or use it. If you receive this e-mail by > mistake, please either delete it without reproducing, distributing or > retaining copies thereof or notify our email administrator at > [email protected] .Note that this is NOT the address of the > person who sent this mail to you but a general administrative address. > The views expressed in this email may be the personal views of the sender > and not of Taylor Nelson Sofres plc unless specifically stated. > Please note that Taylor Nelson Sofres is able to, and reserves the right > to, monitor e-mail communications passing through its network. > ----------------------------------------------------------------- > > ================================================= > To set vacation, Out Of Office, or away messages, > send an email to [email protected] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [email protected] > ================================================= > > ================================================= > To set vacation, Out Of Office, or away messages, > send an email to [email protected] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [email protected] > ================================================= > ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|