| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] state Sync through a VLAN over gigabit ethernet fibre
- To: [email protected]
- Subject: Re: [FW-1] state Sync through a VLAN over gigabit ethernet fibre
- From: "Burton, Chris" <[email protected]>
- Date: Fri, 14 Feb 2003 16:39:19 -0800
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcLUSWYc4xmrP50RTRuscWBnBYcqTgAPtexQ
- Thread-topic: [FW-1] state Sync through a VLAN over gigabit ethernet fibre
If you had a dedicated VLAN due to the amount of sync traffic on high
volume firewalls (State Sync VLAN) and the latency between the two
buildings was not high I am sure that you could do this.
The biggest problem is with the latency and the information on
hand when a failure occurs; latency in the sync time would have the
greatest effect on VPN connections not so much HTTP traffic.
Chris B
Network Engineer
Walt Disney Internet Group: Network Services
-----Original Message-----
From: Josh Fry [mailto:[email protected]]
Sent: Friday, February 14, 2003 8:18 AM
To: [email protected]
Subject: [FW-1] state Sync through a VLAN over gigabit ethernet fibre
Hello
I would like to ask if it is possible to do state Synchronization
between 2 firewalls
in 2 different buildings over a VLAN through a gigabit ethernet
fibre.
In the documentation I have read that they must be physically
connected with a dedicated Mbit connection
both buildings have independent internet connectivity but if one
firewall dies ... traffic will be routed to the other firewall
Kind regards
Josh
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
