[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] Sic failure
You also could try a fw sic_reset. However, you have to notice that this procedure reset the SIC communications with other NG modules, and before do it, you have to manually remove any certificate generated by the CA. I hope this could help... ==================================== Mauricio F. Muñoz Quevedo ============================================== |---------+----------------------------------------------> | | roberto fregoni <[email protected]> | | | Sent by: Mailing list for | | | discussion of Firewall-1 | | | <[email protected]| | | kpoint.com> | | | | | | | | | 01/02/2003 11:37 a.m. | | | Please respond to Mailing list for | | | discussion of Firewall-1 | | | | |---------+----------------------------------------------> >----------------------------------------------------------------------------------------------| | | | To: [email protected] | | cc: | | Subject: [FW-1] Sic failure | >----------------------------------------------------------------------------------------------| Hi all, I have a managment with NG-FP1 and an inspection with 4.1 (Solaris platform). Now I want to substitute the inspection with a new ws with NG FP1 (with the same name and ip). Managment and inspection ping each other. The problem is that the inspection is in UNTRUSTED state and when I try to install the policy it replays me: VPN-1/FireWall-1 policy installation failed for module inspection... Reason: Connection failed - SIC failure VPN-1/FireWall-1 policy installed successfully on managment... So I stopped fw on inspection and than I started cpconfig in order to create a new CA. Then I start GUI and on inspection object I click on Communication but when I try to initialize (with the same password of cpconfig) it replays me: A certificate with this name already exists, please specify a different name and try again. There is anybody out there can help me ? Thanks in advance. Best regards roberto ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|