After I add aliases, they don't survive a
reboot.
(Running SecurePlatform)
I'm using the command
ifconfig eth2:1 192.168.2.1
ifconfig eth2:2 192.168.3.1
Should I be adding these to a file somewhere
instead of just adding via command line?
Regards,
Andrew
>Hmmmm thats weird because I
am using colons in mine and while they do not show
>up in the interfaces section of the config, or the GUI, routing and traffic >to/from them do appear to work fine... >Damo
>I don't know about the others on the list, but we ran into an
issue
>using colons for virtual interface names with FP3 Secureplatform. >Apparently starting with FP3, colons are no longer supported in >interface names. Check Point has confirmed this. Apparently it doesn't >matter because the names of virtual interfaces can be whatever you want >them to be in the interfaces tab. > >Frank >
|