| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] VPN Problem ERROR OCCURRED SKEME:IKE
- To: [email protected]
- Subject: Re: [FW-1] VPN Problem ERROR OCCURRED SKEME:IKE
- From: "Rowden, Ben" <[email protected]>
- Date: Fri, 31 May 2002 18:36:36 +0100
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcIItPJIWVy2hcuVQQyLDoERaV7MsgAE4HNw
- Thread-topic: [FW-1] VPN Problem ERROR OCCURRED SKEME:IKE
Hi,
Are you sure this diagram represents the architecture you want? If yes, then what is the Cisco kit for?
Not sure why you have this problem, but I would check that you have the same set of VPN configuration options on both FW-1 boxes.
Regards
Ben
-----Original Message-----
From: Fab Jonni [mailto:[email protected]]
Sent: 31 May 2002 15:33
To: [email protected]
Subject: [FW-1] VPN Problem ERROR OCCURRED SKEME:IKE
Hello everyone,
this below is my networks sketch where I set up a tunnel VPN between 2 FW-1 4.1 :
LAN-A ----- Cisco VPN 3000 Concentrator-1 ---- FW-1 =====TUNNEL-VPN==== FW-1----Cisco VPN 3000 Concentrator-2------LAN-B
Now when I try to ping to a server in LAN-B from LAN-A everything works fine but when I ping to a server in LAN-A from LAN-B then the following error message appears in the FW logs: "icmp-type 0 icmp-code 0 encryption failure: error occurred skeme: IKE " What does this error mean?
Any insight would be greatly appreciated.
Jonny
_________________________________________________________________
MSN Foto è il modo più semplice per condividere e stampare le tue foto: http://photos.msn.com/support/worldwide.aspx
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail =================================================
To unsubscribe from this mailing list,
please see the instructions at http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected] =================================================
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
