[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] VPN And NAT
Hi, I think this means that you have not configured both sides of the VPN tunnel with the same encryption configuration options. As a note, in order for NAT'd encryption to work you need to use UDP encapsulation. Regards Ben -----Original Message----- From: Andrade Guerra, Marcelo [mailto:[email protected]] Sent: 31 May 2002 17:52 To: [email protected] Subject: [FW-1] VPN And NAT HI Gurus, I need configure VPN between SAP America and my network, The problem is that SAP demands to me that the server who connects must have valid IP Address, my server have invalid ip address but have NAT Static whit valid IP address, and NAT is OK, but when my server connect across the VPN NAT dont work. Check Point Log Viewer say "encryption failure: no response from peer. scheme:IKE Thanks ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|