NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[FW-1] backup interface wouldn't keep quite.



Hi,
 
Firewall 4.1, Nokia 440, IPSO 3.2.1-fcs1, running VRRP on outside, inside, dmz interfaces.
 
Symptom: Regularly, the backup firewall's outside interface changes its state to Master, even though Primary is functioning fine.  Causing slowness in Internet Access.
 
What i find from TCPDUMP is that primary sends VRRP multicast message out every 1 second.  What's odd is that every once in a while, i see Backup sends out one VRRP message.  This causes significant delay in our Internet Access.
 
At the firewall side, VRRP config looks identical to the Nokia's document on how to setup one.  I do have policies to allow vrrp traffics.
 
All the interfaces go to pair of Cisco 4000 switches with various VLANS.  First 2 ports of the switches are configured with VLAN trunking.
 
Originally, firewall's inside and dmz interfaces were connected to Cisco4000 switch with its own VLAN.  Outside interfaces of the firewall were originally connected to Cisco2900 before and we moved them to Cisco4000 switch with its own VLAN.
 
First I thought it was the switch's VLAN trunking config, but I doubt it is that.  If it was the VLAN trunk issue, then i would see the same behavior with inside and dmz interfaces too...
 
 
any thoughts??
 
thanks,
 
Mike


 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.