| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] High Availability
- To: [email protected]
- Subject: Re: [FW-1] High Availability
- From: Steve McNutt <[email protected]>
- Date: Thu, 11 Apr 2002 23:32:05 -0400
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcHhlBgLuDqftosyR8G7U9RL7rUEPAAAAA3gAA81XRA=
- Thread-topic: Re: [FW-1] Voyager access
Well, I suspect you will get a veritable flood of replies on this one :-)
The two HA solutions with FW-1 that I have experience with are Stonebeat Full cluster and the Nokia solution.
The stonebeat setup I worked with used sun E250 enforcement servers with gig E interfaces and a ultra 10 for a management server
I've done numerous setups with nokia boxes using IP 330's and 440's with a variety of interfaces.
The stonbeat was a pain in the a$$, and product support seemed more interested in deflecting blame and making excuses than working the problems. I walked away with a bad taste in my mouth.
The Nokia solution works beautifully. very easy to configure, maintain, and administer. Only drawback is failover can take a couple of seconds. If you require subsecond failover, it's not a good choice.
I cannot comment on rainwall or other solutions, as I have not implemnented and/or supported them.
Have a good one.
Steven McNutt, CCIE #6495, CCSE #6224, MCSE
President
LightningCloud Technologies
bus:cel:[email protected]
-----Original Message-----
From: Arvanitis, Steve [mailto:[email protected]]
Sent: Thursday, April 11, 2002 4:11 PM
To: [email protected]
Subject: [FW-1] High Availability
I am looking at a clustering or load balancing solution for my environment. Does anybody have any suggestions on what I should look at? I am presently looking at RainWall and Checkpoints High Availability module.
Thanks
Steve
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
