[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] General Question on SecuRemote and SecureClient
> Over the weekend, I picked up for myself, a Linksis DSL router for home, and > when I was setting it up, I realized that using the defaults, as many users > would, anyone using one of these devices will be getting the same network, > and potentially the same IP address on their home system. > > What I am wondering about, is will I have any problems if two users, > establish a VPN connection to us, who are using the same internal IP Address > on their home system. By not using IP Pool NAT, the IP Address used within > the corporate network, is the same address on the home system. Will > Checkpoint correctly route the traffic to the correct Remote PC, or will I > likely run into difficulties. > > On a similar note, if I should enable IP Pool NAT to clear up the above > issue, will I need to re-deploy a USERC.C file to the remote PCs or is this > totally internal to the Firewall box. I am asking this because some of our > VPN users are remote vendors who were reluctant to use the software in the > first place, and I don't want to inconvenience them further unless I have > to. IP NAT Pool will not fix this problem. You need to use different addresses on your internal network or the home networks. -don ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|