[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW-1] AW: [FW-1] How Can I add a static route to FW-1 in IPSO 3.4
Hi, 1st and by the way::: the maximum number of subnet bits is 32. Something like /36 does not exist in IPv4. Static routes on IPSO are added via Voyager. However if the FW has an interface in each of the (complete) subnets you do not need a route. If you add a rule like this::: source destination service action 192.168.2.0/24 210.232.69.0/nn req. service accept Your machines are routed to the outter world without NAT. You just have to make sure that the outter machines / routers / default gw knows the way beack to this machines. By adding the external IP of your fw as a default gw for 192.168.2.0/24 on the outer routers/machines. However this will only work on your "own" backbone. On the internet / official backbones no privat addresses are routed. --Joerg -----Ursprüngliche Nachricht----- Von: liu [mailto:[email protected]] Gesendet: Mittwoch, 13. Februar 2002 09:25 An: [email protected] Betreff: [FW-1] How Can I add a static route to FW-1 in IPSO 3.4 I want to make a test enviromnent. The internal ip is 192.168.2.0/24 and the outside is 210.232.69.0/36.I want to access the machines outside and without NAT. Is it possible?Could you tell me how to do it?My platform is on IPSO. Thank you very much! ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|