NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FW-1] VRRP high-avail problem



Title: RE: [FW-1] VRRP high-avail problem

The only documented cause of this would be running 4.1 SP5 WITHOUT the hotfix (can be obtained from Check Point customer download site - requires a login).  Some have also reported this issue when running SP5+hotfix on one member of the pair and an older SP on the other member.

HTH

Dan Hitchcock
CCNP, CCSE, MCSE
Security Analyst
Breakwater Security Associates, Inc.
"Safe Harbor for E-Business"
dhitchcock (at) breakwatersecurity (dot) com
http://www.breakwatersecurity.com
work

The information contained in this email message may be privileged, confidential and protected from disclosure.  If you are not the intended recipient, any dissemination, distribution or copying is strictly prohibited.  If you think you have received this email message in error, please email the sender at [email protected]


-----Original Message-----
From: richard marshall [mailto:[email protected]]
Sent: Thursday, January 24, 2002 7:28 AM
To: [email protected]
Subject: [FW-1] VRRP high-avail problem


Hi Guru's

I'm having a major problem with a pair of IP440s in failover mode with
VRRPmc - When ever i push a new policy, the primary wall at the time fails
and reboots. I am presently looking at a situation where as soon as the
primary comes back-up the secondary fails and reboots! (this doesn't happen
all the time, but is happening as i write this. I'm running IPSO 3.4.1
FCS-5, and FCS-10 though have seen the same problem with older IPSOs too.

does anyone have any ideas?

regards

rich



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.