| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] Routing for 2 vlans
- To: [email protected]
- Subject: Re: [FW-1] Routing for 2 vlans
- From: "Adam D'Alessandro" <[email protected]>
- Date: Wed, 19 Dec 2001 00:19:12 -0500
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcGILMriiDpalBxORCGYmriBu20zFAAHDO4AAADnD6A=
- Thread-topic: Re: [FW-1] Floodgate Problems
Sorry if this comes tru twice.
Hi,
I have a nokia appliance with 3 interfaces.
eth-s3p1c0 has x.x.x.2 from a x.x.x.0/28 network.
eth-s4p1c0 is not used.
eth-s5p1c0 has 10.1.1.1 from a 10.1.1.0/24 network.
I have been assigned 2 vlans from my ISP; both /28 networks.
I want to route x.x.x.0 /28 to one gateway and y.y.y.0 /28 through
another gateway.
Currently my default route is pointing to the ISPs upstream router
x.x.x.1 for vlan 1
I have NAT rules that will translate for both networks.
I have attempted to add 2 gateways to the default route; but to no
avail.
Any suggestions?
Adam
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
