[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] snmp to multiple dest.
Hi, try to put it in a script at the Management-Module, e.g. myalert. myalert has two lines, one for each destination where snmp_trap shall send the trap to. You will need to provide the information also, so the whole line of the log should be given to the commands snmp_trap ip1 and snmp_trap ip2 Hope it helps, best regards Matthias Korg Muller wrote: > Question: > > Need to send a snmp trap to two different > destinations. The "log and Alert" tab under Policy -> > Properties, allows me to enter a SNMP Trap Alert > command which syntax (as I understand it) is snmp_trap > <IP address>. I want to send the trap to two IP > addresses not one. Would you be able to provide any > advice. > > Thanks,Km. > > __________________________________________________ > Do You Yahoo!? > Find the one for you at Yahoo! Personals > http://personals.yahoo.com > > =============================================== > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > =============================================== =============================================== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ===============================================
|