[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] Policy problem
Eric, When you fetch the security policy from the Management Server, take a look afterwards in the $FWDIR/state directory and see if the files that are located in there got changed, updated. These are the ones, as far as I know, that will contain your new security policy. Met vriendelijke groeten - Bien à vous - Kind regards Guy ROELANDTS EMEA GS Internet Expertise Centre - CCSA & CCSE Compaq Software Engineer - Belgium E-mail : [email protected] Tel: +32(02)729.77.44 (options 3 - 3 - 1) Fax: +32(02)729.77.65 ===================================================================== This message may contain confidential and/or proprietary information, and is intended only for the person/entity to whom it was originally addressed. The content of this message may contain private views and opinions which do not constitute a formal disclosure or commitment unless specifically stated. Should you receive this message by mistake please inform the sender immediately. ===================================================================== -----Original Message----- From: Eric Appelboom [mailto:[email protected]] Sent: Tuesday, November 13, 2001 7:57 AM To: [email protected] Subject: [FW-1] Policy problem Hi All I have a CP4.1 problem relating to the installation of a policy. I redid putkeys between management and fwm and both adknowledge new key after fwstop\fwstart I use a fw fetch to management and a policy is copied with a recent timestamp. However the rulebase changes are not applied. The old rulebase remains active. I have checked object.C rules.C on the fwm but the rules are old but the timestamp is new. I have also done a fw unload on fwm issuing a fw fetch which retrieves fine. I understand that the policy gets complied when clicking install in policy editor which it does. It copys the policyname.W to policyname.pf but why doesnt the fw fetch get the correct one? I run fw fetch x.x.x.x (management) and it does get any.all@policyname. I don't think it is authentication problem cause fw fetch works fine. We use a fw fetch because the policy editor GUI's authentication problem between the nodes. Not sure if this is the cause here? (putkeys I know but it donsnt fix this) Help? Thanx Eric Appelboom Office: (+27)Mobile: (+27)*** Disclaimer: The information in this email is confidential and is intended solely for the addressee(s). Access to this email by anyone else is unauthorised. If you are not an intended recipient, you must not read, forward, print, use or disseminate the information contained in the email. Any representations (contractual or otherwise), views or opinions presented are solely those of the author and do not necessarily represent those of the employer or any of its affiliates. =============================================== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html =============================================== =============================================== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ===============================================
|