The only way to do that is to configure half of the stations with a
default
gateway to the first router and the other half with a default router to
the
second router.
Rodrigo
-----Mensagem original-----
De: Bill Husler [mailto:[email protected]]
Enviada: Wednesday, October 31, 2001 3:22 PM
Para: [email protected]
Assunto: [FW-1] Multiple Default Routes on Nokia
We have a Nokia (110) and two upstream routers in parallel and would
like the firewall to use both paths. I added both router's IP addresses
in the static routes panel in voyager for default and gave them both the
same priority (the help panel says this will consider them equivalent),
but when I setup a station before the firewall and continuously ping a
station beyond the routers, it appears to only utilize the second entry.
If I unplug it's ethernet cable, the other route comes alive, but if I
plug it back in, all the traffic reverts to the second route again. Is
there any way to set it up to use both?
Bill
===============================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
===============================================
===============================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
===============================================
