[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] install policy warning
I had the same problem. You have to put in external.if eth-s1p1c0 . The name in the file must match the name of the interface you are using . " ifconfig -a eth-s1p1c0: lname eth-s1p1c0" ----- Original Message ----- From: "Mr Zoid" <[email protected]> To: <[email protected]> Sent: Monday, October 29, 2001 12:22 PM Subject: [FW-1] install policy warning > Hello All, > When I try to install a policy I get the following warning. How Do I correct > it? > When I go into system status it says that the status is disconnect. > I'm assuming that this is because of the warning from trying to install the > policy as the firewall is connected to a router and I can ping it. > > -Art > > Installing Security Policy testing on all.all@fw2 > Using external interface 'eth-s1p1' > > Warning: External Interface was not set by this Loading. Please verify that > $FWDIR/conf/external.if holds the name of your External Interface. > > > > fw2[admin]# cd $FWDIR/conf > fw2[admin]# cat external.if > eth-s1p1 > fw2[admin]# ifconfig -a > eth-s1p1c0: lname eth-s1p1c0 > flags=e7<UP,PHYS_AVAIL,LINK_AVAIL,BROADCAST,MULTI> > inet mtu 1500 ***public ip**/** broadcast ... > phys eth-s1p1 flags=133<UP,LINK,BROADCAST,MULTICAST,PRESENT> > ether 0:xxxxxxxx speed 100M full duplex > > _________________________________________________________________ > Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp > > =============================================== > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > =============================================== > > =============================================== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ===============================================
|