[FW-1] CP HA configuration

["Roelandts, Guy" <Guy.Roelandts@FW1-NOSPAMCOMPAQ.COM>]

Hi all,

   If someone in running/using the CheckPoint High Availability module,
could he
 confirm the following : when you upgrade a single installation, where the
Firewall
 module and the Management Server are already separated, it seems you need a
 separate LAN where you'll put the Firewall Modules on, with their unique IP
addresses,
 and the Management Server, is this really TRUE ? This means that I need at
least 4
 Interfaces to be able to build a HA solution ? One dedicated to the
Management, one
 for the SYNC, one to connect to my internal LAN and one to the Internet ?

   Or is there a way to configure the Firewall in such a way that both the
Internal LAN
 and the Management LAN are connected to the same LAN ?

Met vriendelijke groeten - Bien à vous - Kind regards

Guy ROELANDTS
EMEA GS Internet Expertise Centre - CCSA & CCSE
Compaq Software Engineer - Belgium
E-mail : Guy.Roelandts@compaq.com
Tel: +32(02)729.77.44 (options  3 - 3 - 1)
Fax: +32(02)729.77.65

=========================================
This message may contain confidential and/or proprietary information,
and is intended only for the person/entity to whom it was originally
addressed. The content of this message may contain private views and
opinions which do not constitute a formal disclosure or commitment
unless specifically stated. Should you receive this message by mistake
please inform the sender immediately.
=========================================

===============================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
===============================================