[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] MetaIP/Dhcp
This is because when using Microsoft DHCP server or Metaip the "Primary" interface is the only interface that can give out DHCP subnets, and can only assign addresses that belong to the specific subnet the primary interface is on. The only way microsoft DHCP works is by using a seperate server that has its primary interface enabled with DHCP and giving out the other subnet as assignments. -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Larry Pingree Sr. Security Engineer/Check Point Instructor CCSA, CCSE, CCSI, ICE, ICI, NSA Website: http://www.SiegeWorks.com <http://www.siegeworks.com/> -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of Mauro Conosciani Sent: Tuesday, August 21, 2001 7:58 AM To: [email protected] Subject: [FW1] MetaIP/Dhcp Hi It looks like the metaip/dhcp works only creating a lease pool with the same ip address as the metaip/dhcp server....... my metaip/dhcp server has the ip 10.6.xx.xx/16 (only 1 NIC) first leasing pool is 10.6.0.0/16 works fine second leasing pool 10.2.0.0/16 doesn't work the status is pending/unknown the clients do not get any ip at all, the router is configured with dhcp service on..... Can anyone give a clue about that 'cause I don't think metaip/dhcp works only in a flat network....doesn't it ? Ciao ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|