|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: AW: [FW1] Problems with FW1 and NT
This could be an IRQ conflict issue.Remove modem,if any,change NIC slots on
motherboard to see if it helps.
In a message dated 6/10/2001 12:40:56 AM Eastern Daylight Time,
[email protected] writes:
it seems to be a a hardware-fault (driver ?). check your network cards and
drivers. may your mainboard is currupt.
don´t think that this is a prob of fw/1.
frank
-----Ursprüngliche Nachricht-----
Von: Christian Betz [mailto:[email protected]]
Gesendet: Freitag, 8. Juni 2001 16:06
An: 'Ben Stoll'; [email protected]
Cc: [email protected]
Betreff: AW: [FW1] Problems with FW1 and NT
Ben,
freeze means in your case bluescreen? Or is it the effect to have 100%
utilisation without any cause and no data transfer?
1. is a memory bug, maybe hardware or the system can't allocate RAM sites
2. I've seen this with a SP bug. reinstall NT SP and Cp FW-1 SP separately
Hope it helps. Regards,
Christian Betz
System Engineer
eSecurity Solutions
Prodacta Systemhaus GmbH
Pforzheimer Str. 160 Fon: +49 (0) 7243 382 308
D-76275 Ettlingen Fax: +49 (0) 7243 382 107
Germany Mob: +49 (0) http://www.prodacta.de
-----Ursprüngliche Nachricht-----
Von: Ben Stoll [mailto:[email protected]]
Gesendet: Donnerstag, 7. Juni 2001 17:22
An: [email protected]
Cc: [email protected]
Betreff: Re: [FW1] Problems with FW1 and NT
First of all you should make sure you have removed all services except for
SNMP. I also think you need to confirm that there are no TSR's for your NIC
running. Then check to make sure there are no funny CMOS settings. e.g.
HDD powerdown.
Regards,
Ben
----- Original Message -----
From: <[email protected]>
To: "Chris H" <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, June 06, 2001 3:49 AM
Subject: Re: [FW1] Problems with FW1 and NT
Chris,
Thanks for your advice, but I've tried it without success.
I stopped the StoneBeat service and FW service. I applied the SP6a. But
this afternoon I had the server locked up again.
Has anyone any other advice?
Regards.
|--------+----------------------->
| | Chris H |
| | <cghoerichs@y|
| | ahoo.com> |
| | |
| | 29/05/2001 |
| | 18.54 |
| | |
|--------+----------------------->
>-----------------------------------------------------------------------|
| |
| Para: Benito Gallardo García/CES, |
| [email protected] |
| cc: |
| Asunto: Re: [FW1] Problems with FW1 and NT |
>-----------------------------------------------------------------------|
----------------------------------------------------------------------------
----
>
>
> I have seen this when the server has been upgraded or
> a new SP was installed while the FW service was still
> running. The server will run, then for some reason
> later on it does just what you said. It locks up. I
> have seen it several times and sometimes it causes a
> DRWATSON. A re-upgrade or re-application of SP with
> the FW service stopped solved the problem.
>
> --- [email protected] wrote:
> >
> >
> >
> > Hello,
> >
> > I have 2 FW-1 4.1 SP2 running on 2 NT 4 SP6a
> > servers. I have them in a
> > Online-Standy configuration with StoneBeat 2.0.
> >
> > Everything works OK, , but the server freezes from
> > times to times.
> > Sometimes it freezes after an hour other after 4-5
> > days. There's no
> > evidence at the FW-1 log, or the NT eventlog of the
> > cause of those hangs.
> >
> > Has anyone any idea or hint to find out what's
> > happening?
> >
> > Thanks for your help.
> >
> > Benito
> >
|
|