[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] cannot get address of host
On the Nokia there is a place to put the host name of the firewall that you have built. When installing the Nokia it will ask for a host name, for some reason it does not populate the host name into voyager. I forget where exactly it is but if you look around you will find it. In Solaris you should have an interface file and a host file that will let the OS know the host name of the server. Thomas Stala [email protected] Hope this helps -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of [email protected] Sent: Thursday, May 31, 2001 10:52 AM To: [email protected] Subject: [FW1] cannot get address of host Good afternoon. Hi all, I´m receiving the message listed below when I´m installing my security police. I would like to found the source of this warning. Does anybody have any ideas about this ? Thanks in advance. XXXX.W: Security Policy Script generated into XXXXpf x: "C:\WINNT\FW\conf\XXXXpf", line 111: WARNING: cannot get address of host <xx> "C:\WINNT\FW\conf\XXXXpf", line 111: WARNING: will not create a value table for <target_listxx> Compiled OK. Installing Security Policy C:\WINNT\FW\conf\XXXXpf on all.all@XX Installing Security Policy on XX succeeded "A presente mensagem tem objetivo meramente informativo e não constitui obrigações ou responsabilidades das empresas integrantes do Grupo Safra". ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|