[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW1] SecuRemote Problem - Urgent
Dear Sir or Madame, I have a problem with VPN under FW-1. As the following the scenario shows: One Fw-1 4.1 Module One Management Station 4.1 I´m trying to connect to the firewall because it´s only machine that have an external ip address. Fw-1 has the correct license, but the license was generated to my FW-1 internal ip address. The Fw-1 objetct has the internal ip address too. The interfaces are corrected assigned. My Management Station has an internal ip address only, and doens´t make NAT. I already got SecuRemote licenses installed on my firewall module and management station. When I try to connect with a SecureRemote under dial up, I have the following message: "Error: Site ..xxx.xxx says that it is not a Certificate Authority. Check whether you have got the right Ip-address for xxx.xxx.xxx.xxx , and check with the Fw-1 system there whether xxx.xxx.xxx.xxx is indeeded a FW-1 control station" Note: xxx.xxx.xxx.xxx it´s my firewall module´s external address. Must I open my Management Console across Internet? What am I suppose to do to solve the problem? I already installed the VPN and SecuRemote licenses in my firewall module and in my Management Station. I´m using FWZ encription. But, should i make a static NAT for my Management Station? It has only an internal ip address. I´m trying to connect under my firewall module. Is it possible? If yes, how? Thanks a lot and Best Regards, Vinicius Dalesandro ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|