[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] VRRP multicasts
Hi, I guess you have to block the multicast traffic on the ACL's on the routers.. Using the fail-over cable is irrelevant as the multicasts are distributed on the segment/VLAN in which the monitored circuit interfaces are resident. Hope this helps.. Nils Kolstein Internetworking Engineer Planet Media Group E-mail: [email protected] Tel.: (+31)> -----Original Message----- > From: Tim Holman [mailto:[email protected]] > Sent: Wednesday, April 11, 2001 8:28 PM > To: [email protected] > Subject: [FW1] VRRP multicasts > > > > I've setup 2x Nokia IP440s using monitored circuits. > I now want to prevent VRRP multicasts from being broadcast upstream. > As I have a failover cable between the two machines, is it > possible to > restrict BTTP to that cable only, or do I have to filter out > the multicasts > using border routers ? > > Tim > ______________________________________________________________ > ___________ > Get Your Private, Free E-mail from MSN Hotmail at > http://www.hotmail.com. > > > > ============================================================== > ================== > To unsubscribe from this mailing list, please see the > instructions at > http://www.checkpoint.com/services/mailing.html > ============================================================== > ================== > ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|