NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [FW1] Static NAT



You probably didn't configure the firewall object as 
"VPN - Firewall-1 installed"
in the workstation properties.
Michael.

-----Original Message-----
From: [email protected]
[mailto:[email protected]]
Sent: Thursday, April 05, 2001 4:43 PM
To: [email protected]
Subject: [FW1] Static NAT



Does anyone know what could cause the non-displayment of the firewall
object in the workstation properties/NAT tab/INSTALL ON field when
attempting to configure a static NAT between a http or ftp device in the
private network and the outside world?   Only the ALL selection is
displayed and choice of it results in a failure to push the policy.



============================================================================
====
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
============================================================================
====


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.