|
|
|
|
|
|
|
|
 |
 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] Static NAT
your fw object should be defined as INTERNAL, FW-1 installed AND gateway. Is it set? best wishes Aylton ----- Original Message ----- From: <[email protected]> To: <[email protected]> Sent: Thursday, April 05, 2001 11:43 AM Subject: [FW1] Static NAT > > Does anyone know what could cause the non-displayment of the firewall > object in the workstation properties/NAT tab/INSTALL ON field when > attempting to configure a static NAT between a http or ftp device in the > private network and the outside world? Only the ALL selection is > displayed and choice of it results in a failure to push the policy. > > > > ============================================================================ ==== > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ============================================================================ ==== > > ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
