also check that you don't prohibit that traffic with your anti-spoofing
rules, I made that mistake a few days ago ;-)
Patrick
>>> "Jeff Richmond" <
[email protected]>
03/04/01 21:38 >>>
You need to route to the next hop, not to the
IP address of the host directly. The
NAT translation on the firewall provides
the appropriate IP mappings, so you'll just
need to add the following route
statement:
route add 208.x.x.x 10.10.10.1
Good
luck.
-Jeff
CGI wrote:
> I have a
configuration:
>
> internet
>
|
> sun firewall box 10.10.10.18
>
|
> router 10.10.10.1
> |
>
Router 10.10.20.1
> |
> host
10.10.20.3
>
> When I add a NAT
> Route add 208.x.x.x
10.10.20.3 I receive a error
> message:
> Network is
unreachable.
> I can not NAT a computer which is in the 2nd
hup??
>
> Thanks
>
>
_______________________________________________________
> Do You
Yahoo!?
> Get your free @yahoo.ca address at
http://mail.yahoo.ca>
>
================================================================================
>
To unsubscribe from this mailing list, please see the instructions
at
>
http://www.checkpoint.com/services/mailing.html>
================================================================================
================================================================================
To unsubscribe from this mailing list, please see the instructions
at
http://www.checkpoint.com/services/mailing.html================================================================================