[FW1] SecuRemote connects to which fw interface (again)?

["Hartmann, Josef" <J.Hartmann@FW1-NOSPAMsecunet.de>]

Hi,


I am running a fw with quite a few interfaces. Now I would like to setup a
VPN. After some troubles userc.C is now loaded, however SecuRemote does
connect to the primary interface of the firewall not to the interface which
the client has access to.

Unfortunately userc.C is encrypted. Setting the appropriate parameter in
userc.C to false or removing it did not help me.

A small figure to illustrate this:

                                 Network C

                                         |
                                         |
                             _______________
                             |                        |
network A   -----------|         FW           |----------------- Network B
---------          VPN Client
this IP address is   |                         |
set the one of the   |                         |
FW object.             --------------------------
                                         |
                                         |
                                 Network D

As you can see the Gateway address of the SecuRemote Client should be
interface B however, after the Topo downloaded forces the VPN Client to use
interface A as gateway but that's silly, isn't? Do I have to use Interface B
as the "primary" (the IP Address given in the general tap of the workstation
properties of the firewall object) interface of the firewall object?




Any hints?


Cheers,

Josef


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================