[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] Eventlog selection
Hi, I try this way too, (usually I use select/by columns/interface) but the result is the same. Event log browse replay with "no match" but I see the name of interface (like N1003) when I listed all event log. Perhaps I should say that I use NT platform. LP Matej ----- Original Message ----- From: "Thomas Borger" <[email protected]> To: <[email protected]> Sent: Tuesday, February 13, 2001 12:18 PM Subject: Re: [FW1] Eventlog selection Hi Matey, >we upgrade FW-1 with VPN 4.0 on FW-1 with VPN 4.1 SP 2. When I check events >in fw event log I usually select one of interfaces to view the log entries >on this selected interface. >This was working without any problems until upgrade. I see the interface >names when I have full view of event log. I just cannot select view on >selected interface. Is this a bug or my mistake? Click with the right mousbutton on the Interface-column and then use "selection" There you can select wich interface you want to view and whether inbound or outbound! regards Thomas ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|