[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] Corrupt .W file or something else?
you can try recompiling your rulebases.fws file. That is the file that the GUI actually uses to read the policies, the .W file is what gets complied to be pushed to the firewalls. Anyhow, there's a doc on phoneboy that explains all this pretty well... http://www.phoneboy.com/fw1/faq/0136.html according to phoneboy, the command to recomplie your rulebases.fws file is as follows: $FWDIR\FW\conf> for %i in (*.W) do fw fwm -g %i I've never had much luck with that, however... I've done better with $FWDIR\conf> for %i in (*.W) do fw m -g %i (note: not FW FWM but simply FW M) or maybe I'm just smoking crack. It's been a while since I needed to run that command on an NT box... try 'em both and see what works! Regardless, if you're running 4.0 version of the management station on win2k, that could be the problem right there.. last I checked, only 4.1 (w/ some service pack) was supported. If it IS 4.1, and you simply "copied" the *.W files over from a 4.0 MS, you got really lucky that that's all that broke. Because that just shouldn't work. Additionally, check your video drivers. Sounds goofy, but it's worth a shot. Regards jakevil ----- Original Message ----- From: "John Hahn" <[email protected]> To: <[email protected]> Sent: Thursday, February 08, 2001 2:44 PM Subject: [FW1] Corrupt .W file or something else? > > Hi all, > > I have a strange problem with my Policy editor. > > Yesterday (2/7) I built a WIN2K Server as a new Management Console to > replace a WINNTv4.0 Management Console. Copied over all files in the 'CONF' > directory from the old Management Console to the new Console. I have > connectivity to all six of my FW-1 units. (All are NOKIA platforms, 3 are > IP/330, 3 are IP/440). All are logging to the new Management Console. > Yesterday I was able to push Policy to all F/Ws. I monitored various ports > of the F/Ws and see expected traffic. > > Today I tried to edit a Policy with 110+ rules. File 'IP440.W' I can open > the file fine, scroll down to rule 62 then get garbage. I again pulled the > file off the old Management Console and copied it to the new Console. Same > results. > > Any ideas? > > > ______________________________________________ > FREE Personalized Email at Mail.com > Sign up at http://www.mail.com/?sr=signup > > > ============================================================================ ==== > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ============================================================================ ==== > ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|