NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[FW1] FW-1 100% cpu usage



Hello,

I am having some problems with our new FW-1 4.1sp2 (on Solaris 2.6/sparc)
setup.  We are running two firewalls in an HA environment (using Stonebeat
Fullcluster).  The first one is running in production, and we want to bring
the second node online.  As soon as I bring the secondary firewall up (using
fwstart), the fw process uses up to 100% cpu resources in only a couple of
seconds after starting it.  This causes the primary one to slow down too and
slows down the network.

I am unable to find any error messages in the log viewer, local syslog files
or on the console.  Nothing is indicating what could cause this process to
use 100% resources.  When I check the connection table of the secondary
firewall, it looks like it is syncing just the way it is supposed to, so it
is hard to figure out what is causing this.  We also run Stonebeat
FullCluster, in loadbalancing configuration (before we shut down the
secondary firewall, we were running Stonebeat HA, where the secondary node
is in standby).  I doubt that Stonebeat is causing this since it is the
actual fw process that is using 100% cpu resources.  Any suggestions?
Thanks in advance.

Best regards,


Daniel


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.