NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FW1] Firewall-1 and pcAnywhere v9.0



Rales,

It depends on where it is coming from.  If it have an static IP, you can
create a network object fro that workstation.

Create a rule:

Source                Destination                    Service
new object -----> host behind FW -----> PCAnywhere

Right click on the "Service" and Add, locate PCAnywhere (it already have
those 2 ports) and click OK.

Install the policy and test it.  Hope this helps

Regards,
Joaquin
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 16, 2001 3:23 PM
Subject: [FW1] Firewall-1 and pcAnywhere v9.0


>
>
>
> Hi folks,
>
> As you probably know, pcAnywhere uses ports 5631 and 5632.
> Does anyone know how to configure Firewall-1 to remote control a host
behind the
> firewall.
> THX
>
> Rales
>
>
>
>
>
============================================================================
====
>      To unsubscribe from this mailing list, please see the instructions at
>                http://www.checkpoint.com/services/mailing.html
>
============================================================================
====
>



================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.