[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] Upgrading from single FW-1 to HA
If your going install on totally new boxes, then load Fullcluster first get them loadbalancing NT as a router (if your using NT) then install the FW inspect engine. If your worried about down time. Install one, leave it offline, plug it into your network then when you unplug your original firewall, put SB online. Install SBFC on the second box and leave it offline. make your policy changes to push rules to Cluster object instead of FW object, then push policy, bring it online and your set to go. If your using CVP, make sure you have unique IP address and a common virtual on the appropriate interfaces. Good Luck Andrew Bagrin Secure-1www.secure-1.com ----- Original Message ----- From: Brian Tan Wee Beng <[email protected]> To: <[email protected]> Sent: Tuesday, November 14, 2000 1:07 AM Subject: [FW1] Upgrading from single FW-1 to HA > > Hi > I need to upgrade my present single FW-1 v4.1 to two firewall running on > Stonebeat Full Cluster.Any advice on how should i go abt doing so??Anything > that i should specifically look out for??Thanks. > > > _________________________________________________________________________ > Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. > > Share information about yourself, create your own public profile at > http://profiles.msn.com. > > > > ============================================================================ ==== > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|